MM-401™MPU-401 Compatible MIDI Interface for the IBM PC andCompatibles45 E. Saint Joseph St. • Arcadia, CA 91006Tel: 626-445-2842 • FAX: 626-445-7564
8. You will be prompted for a disk drive from which to readthe Windows 3.1 drivers. Insert the proper Windows diskinto your floppy disk drive, and,
Trouble-ShootingIf you are having problems using your MM-401 it is probably agood idea to reread this manual and make sure you have prop-erly installe
isn’t working with Windows.SOLUTION: Make sure you have an MPU Windows driverinstalled. This driver could be either the Roland MPU-40
address/port and interrupt/IRQ to match the settings on theMM-401. SYMPTOM: My keyboard shows “MIDI Data Error,” or “MIDIBuffer Full.” SOLUTI
How to Change the Address and IRQ SettingsRecent updates to the MM-401 have necessitatedchanges in how the I/O address and IRQ are set. Theinstruction
Lifetime Limited WarrantyMIDIMAN warrants that this product is free of defects in materials andworkmanship under normal use so long as the product is
ages set forth herein shall remain in full force and effect.If you have any questions, comments, or suggestions about theMM-401 or any MIDIMAN product
FCC COMPLIANCEThe MM-401 complies with Part 15 of the FCC rules. Operationis subject to the following conditions:(1) This device may not cause harmfu
Package ContentsThe MM-401 package consists of the interface card, a MIDIIn/Out adaptor cable, and a diagnostics and utilities disk.FeaturesT
loaded the Roland MPU-401 driver. This can be done by openingthe *Control Panel* icon in the *Main* Group and clicking on the*Drivers* icon. For fu
IMPORTANT: When using a DOS program, you need to makesure that the interrupt/IRQ and address selected on your MM-401 are also selected within your
The following table shows the possible address locations and cor-responding switch positions:Switch:1 2 3 4 Address Location(Hex)off off off off 200Ho
The following table shows the possible interrupt numbers andcorresponding switch settings:Switch:5 6 7 8 Interrupt NumberON off off off 2 (d
Mechanical InstallationTo mechanically install the MM-401, do the following:1. Turn off your computer.2. Remove the cover and position the compu
WindowsThe installation of the MM-401 is simplified by clicking on the*Driver* icon found under the *Control Panel*. The *ControlPanel*
Kommentare zu diesen Handbüchern