M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Bedienungsanleitung PDF herunterladen (Seite 28)

APPENDIX 4

To put 003 in Pro Tools mode:

1. Make sure the 003 unit is properly connected to the computer and

powered on.

2. If Mute is disabled (unlit), enable Mute by pressing the Monitor Mute

switch so that it is lit.

3. Launch Pro Tools LE and open or create a Pro Tools session.

MIDI Mode

003 is in this mode when either the MIDI Map A or B switch is enabled (lit). In

this mode, 003 functions as a MIDI control surface for external devices and

applications other than Pro Tools. MIDI mode can be enabled in Pro Tools

mode, Third-Party Software mode, or Standby Mode.

Third-Party Software Mode

003 is in this mode when the 003 unit is connected to a computer and you

launch a third-party audio application (such as iTunes or Ableton Live), and

then use 003 as your playback or recording device. You can also use 003 MIDI

ports as you would those on a standard MIDI interface. In this mode, the unit

displays ‘Working’ in the top row of the LCD.

On Windows, ASIO- and WaveDriver-compatible applications are supported.

WaveDriver supports playback only. On Mac, CoreAudio Driver applications

are supported.

Utility Mode

003 is in this mode when the Utility switch is enabled (flashing). In Utility

mode, you can run pre-programmed diagnostic tests of the 003 unit (such as

fader movement and LEDs). The Utility switch is unavailable in Pro Tools mode.

Rear Panel

Figure A4.15

Digi 003 rear panel.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 52 53

Keine Kommentare

M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Bedienungsanleitung Seite 28